Cub Cadet LTX 1040 LTX 1040 Operator's Manual - Page 22
Adjustments - service manual
View all Cub Cadet LTX 1040 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Adjustments WARNING! Shut the engine off, remove the ignition key and engage the parking brake before making adjustments. Protect your hands by using heavy gloves when handling the blades. NOTE: Check the tractor's tire pressure before performing any deck leveling adjustments. Refer to Tires in the Service Section for information regarding tire pressure. Leveling the Deck (Front To Rear) The front of the cutting deck is supported by a stabilizer bar that can be adjusted to level the deck from front to rear. The front of the deck should be between 1⁄4-inch and 3⁄8-inch lower than the rear of the deck. Adjust if necessary as follows: 1. Park the tractor parked on a firm, level surface and place the deck lift lever in the middle position. 2. Rotate the blade nearest the discharge chute so that it is parallel with the tractor. 3. Measure the distance from the front of the blade tip to the ground and the rear of the blade tip to the ground. The first measurement taken should be between 1⁄4" and 3⁄8" less than the second measurement. Determine the approximate distance necessary for proper adjustment and proceed, if necessary. 1. Locate the hex lock nut on the end of the deck hanger rod. See Figure 6-4. Leveling the Deck (Side to Side) If the cutting deck appears to be mowing unevenly, a side to side adjustment can be performed. Adjust if necessary as follows: 1. With the tractor parked on a firm, level surface, place the deck lift lever in the middle position and rotate both blades so that they are perpendicular with the tractor. 2. Measure the distance from the outside of the left blade tip to the ground and the distance from the outside of the right blade tip to the ground. Both measurements taken should be equal. If they're not, proceed to the next step. 3. Loosen, but do NOT remove, the hex bolt on the left deck hanger bracket. See Figure 6-5. 4. Using a wrench, raise or lower the left side of the deck by turning the adjustment gear. See Figure 6-5. Hex Bolt Adjustment Gear Figure 6-5 The deck is properly leveled when both blade tip measurements taken in step 2 are equal. Retighten the hex bolt on the left deck hanger bracket when proper adjustment is achieved. Parking Brake Adjustment If the tractor does not come to a complete stop when the brake pedal is completely depressed, or if the tractor's rear wheels can roll with the parking brake applied (and the shift lever in neutral), the brake is in need of adjustment. See your Cub Cadet dealer to have the brake properly adjusted. Adjusting the Seat Figure 6-4 Refer to the Set-Up and Assembly section of this manual for seat 2. To raise the front of the deck, tighten (thread inward) the adjustment instructions. hex nut against the front hanger bracket. WARNING! Before operating the tractor, make 3. To lower the front of the deck, loosen (thread outward) the sure the seat is engaged in the seat-stop. Engage the hex nut, away from the front hanger bracket. parking brake. Stand behind the machine and pull See Figure 6-4. back on seat until it clicks into place. 22 Section 6 - Maintenance & Adjustments